Probably over engineered it a bit, but wanted to be sure I had plenty of storage, easily accessible. Had my buddy 3D print divider brackets to hold 1/4” PVC sintra board to make slots/ sections where I’ll store 4 3600 boxes inside. Have to grab them this week to install. Should still have plenty of room to fit a few other miscellaneous things in there as well.
Built on top of 3/4” PVC pipe risers so nothing gets too wet and the scuppers can still drain well if needed. Rod holders at an angle to keep them from getting in the way. Added ball bungees to hold the rods in place as well. Everything is secured so even if I flip this bad boy in 20’ waves, it’s going to stay on lol. Added a small zipper pouch on the outside I plan to use for holding leader spools and as a catch all for trash/ used soft plastics/ etc. Couldn’t think of anything else needed but I’m sure I will after the maiden voyage!
Posted by GlowUpAndThrowUp