What strength of braid is recommended for my Penn Fierce 3 6000 setup?
What strength of braid is recommended for my Penn Fierce 3 6000 setup?
Posted by FunGarage2022
5 Comments
biguuey on
I’d either run 30 or 40 lb braid on a 6000 in general depends what you’re using it for
Vinca1is on
Not that the strength they list makes any sense usually, but I try to stick within the braid strength. So I’d probably do 30-40. I
GeoHog713 on
It literally says what braid to use on the rod.
eclwires on
30lb for plugs, 40 or 50lb for chunking.
MellowG7 on
30# braid is good. Fierce are decent setups, but I wouldn’t push them too hard or near their max. Where if it were, say a Slammer , Id line it on the higher end. You can push some models harder than others for sure.
5 Comments
I’d either run 30 or 40 lb braid on a 6000 in general depends what you’re using it for
Not that the strength they list makes any sense usually, but I try to stick within the braid strength. So I’d probably do 30-40. I
It literally says what braid to use on the rod.
30lb for plugs, 40 or 50lb for chunking.
30# braid is good. Fierce are decent setups, but I wouldn’t push them too hard or near their max. Where if it were, say a Slammer , Id line it on the higher end. You can push some models harder than others for sure.