_fuckernaut_ on November 25, 2025 4:19 am Take the spool off and tighten the nut that holds the rotor down. Note that sometimes (but not always) this nut is reverse threaded
LetsMakeSomeBaits on November 25, 2025 4:20 am Take the spool off and there should be a nut at the bottom of the spindle. Get that gripping the thread and tighten it up.
2 Comments
Take the spool off and tighten the nut that holds the rotor down. Note that sometimes (but not always) this nut is reverse threaded
Take the spool off and there should be a nut at the bottom of the spindle. Get that gripping the thread and tighten it up.