Single point of failure hang on back 😂
3d printed a lid. Had enough room to stuff a water heater and an air stone into it. I also 3d printed a cage where I put a small polishing filter. This particular HOB also has UV built in. It’s pretty nice not needing any other tubes or wires going into the tank.
Posted by Stuffstuff1
2 Comments
This is where I think I’m headed with this hobby.
DIY HOB/Canister filters. That way I can choose my own pumps and layout etc.
You did a neat job on the print, what filament did you use?
Nice I diy my sump
https://preview.redd.it/tgsudoqyicag1.jpeg?width=2252&format=pjpg&auto=webp&s=1c4ec84e452fb72c122cdb51b8b5ef3f04b26007