Tank is 200l, stand and setup is secondhand and came as is.



Posted by Dapper-Armadillo5143

5 Comments

  1. Yes you should put a piece of wood and a piece of foam. Rimless tanks should have a fully supported bottom, rimed tanks only need the edges supported.

  2. Capybara_Chill_00 on

    It took me a few minutes to comprehend what I was seeing. That is a time bomb – rimless tanks must be supported evenly across the entire bottom pane, or risk catastrophic failure meaning that basically the bottom collapses and everything dumps out.

    You need to drain that, carefully move it to a level, even surface, put a full sheet of 1/2” plywood over the whole surface area of the stand, then put a self-leveling foam mat on top of that before putting the tank back.

    I would move with a purpose.

  3. Hairy_Figure_8061 on

    Stand isn’t built very well either the screws or bolts are carrying all the weight and while it might be fine forever I wouldn’t risk it

Leave A Reply