I bought a Striker 4 a year or two ago used and it didn't come with any hardware to secure the transducer. I bought a Scotty 141 mount, but with both M5 and 10-32 screws the assembly is very loose. I cannot tighten it any further. I even have 3D-printed spacers and it's still loose. I need a solution tonight because I'm going out on the water at 7AM tomorrow.
Posted by PHWasAnInsideJob
2 Comments
Play with washers at a hardware store till you eliminate the loose clearances
The stock parts have a rubber tube thing that helps grip. (thread spool shaped) But it was also just really damn tight. Go to the plumbing section and get rubber gaskets for repairing faucets, and stack some stainless hardware and those until it’s tight.